From a leaking joint behind a bath panel to a boiler that keeps losing pressure, Drainplumb handles the plumbing a London property throws up, and a single call settles which part needs doing first.
In Short
- What to do first when a pipe bursts or water appears
- Why a basement flat needs different plumbing thinking
- How a repeat blockage differs from a one-off one
- What the written price settles before any work starts
Drainplumb is a plumbing and drainage business covering London, and its drain cleaning in London sits alongside heating, bathrooms and leak work as one range. You describe the job at no charge and get a written price before any work starts.
Tell Drainplumb what the problem is, anywhere in London, and get a written price before any plumber starts work.
Emergency Plumbing Repairs
Burst pipes and overflows
In a Victorian terrace, supply pipes often run under floorboards and behind bath panels, so a burst rarely shows itself where it starts. A copper pipe splits at a joint or where something has knocked it, and the water travels along the joist before it stains the ceiling below. The first job is the stopcock, then the tap to drain the system down, and then the call.
Basements and sewer flooding
London basements are vulnerable to flooding, and the Greater London Authority says basement plumbing should account for possible sewer flooding when drainage systems are overwhelmed. That makes pumped drainage and a non-return valve on the waste line worth knowing about for any basement flat. A wet floor in a lower ground room is a plumbing problem first and a decorating problem later. Shut the water off first.
Describe your plumbing problem anywhere in London to Drainplumb at no charge and get a written price before any work starts.
Boiler and Central Heating Services in London
Boiler faults and servicing
Boilers in London flats often sit in a kitchen cupboard with the flue run through an outside wall, so access decides how a job goes. A pressure gauge that keeps dropping points to a leak somewhere in the sealed system, and a boiler that cuts out often traces back to the pump or a blocked heat exchanger. One call covers both a plumber in London and heating in London, whichever room the fault is in.
Radiators and pipework
Cold patches at the bottom of a radiator mean sludge, and cold at the upper edge means trapped air. Thermostatic radiator valves stick in older systems and stop a radiator heating at all. Bleeding, replacing a valve or fitting a new radiator are all routine jobs on copper pipework. A radiator that leaks at the valve spindle often needs only a new packing or a new valve, not a new radiator. Check the gauge before you call.
Blocked Drains and Drainage Repairs
Sinks, toilets and gullies
Under older London streets, clay and cast-iron drains settle over the decades, and a joint that has moved holds back paper and grease. A slow sink usually has a fat build-up in the trap or waste pipe. A toilet that won't clear points further down, at the soil pipe or the drain run. Drain cleaning in a mansion block is often a shared stack problem, which changes who needs to be told.
When clearing is not enough
A drain that blocks again and again is rarely a blockage. It's a cracked pipe, a displaced joint or roots in the run, and clearing it only buys time. Repair is a separate job from clearance, and the written price says which one you're agreeing to. Clearing fixes the blockage. Repair fixes the cause.
Plumbing Installations and Upgrades for London Homes
Taps, toilets and bathrooms
Post-war tower blocks and mansion blocks carry shared risers and stacks, so new work has to fit what's already in the wall. Replacing a tap or a toilet is simple. Moving a basin or fitting a whole bathroom means isolation valves, new waste runs and a check on the fall of every pipe. The work is staged room by room, so the rest of the home stays usable.
Hot water and underfloor heating
A hot water cylinder in a Victorian airing cupboard can be replaced or repaired, and the choice between vented and unvented depends on the incoming supply. Underfloor heating suits a ground-floor extension or a new bathroom floor, wet system or electric mat, and the floor build-up decides which one fits. A cylinder is easiest to swap when the pipework around it is tidy and the isolation valves still turn. Good pipework is invisible when done.
Leak Detection and Water Damage Repairs
Following the water back to its source
A stain on the ceiling of a converted Victorian villa is rarely under the leak that caused it. Water follows the joists, so tracing a leak means working back through the pipework, not following the mark on the plaster. Joints, compression fittings and old washing machine hoses are the usual places. The method is the same for a flat near St James's Park as it is anywhere else, and a plumber in City of Westminster follows it too.
Repairing what the water left behind
Once the leak is stopped, the pipe is repaired or replaced and the area is left ready for the finishing trades to dry out and redecorate. The quote settles the scope before work starts, so you know what's included. Stop the leak, then dry it out.
Describe your plumbing problem anywhere in London to Drainplumb at no charge and get a written price before any work starts.
Commercial Plumbing and Maintenance
Shops, cafes and small offices
A shop or small office has fewer fixtures than a home and more people using them, so a failed tap or a running cistern shows up fast. Float valves, flush mechanisms and waste traps are the usual culprits, and a dripping cistern wastes water every hour it runs. If you're searching for a plumber near you in London, we cover Greater London and the towns around it.
Planned maintenance around the business
The work is scheduled around opening hours where it can be, so the business keeps trading. A local plumber in Islington covers the same ground for shops and offices there. You describe the job at no charge and get a written price before any work starts. Plan the work around the business.
Describe your plumbing problem anywhere in London to Drainplumb at no charge and get a written price before any work starts.
Common Questions About Plumber in London
How much does a plumber charge per hour in London?
That depends on the job, so a figure before we know what's involved would mean nothing. You describe the job at no charge and get a written price before any work starts, so the scope and the price are agreed together.
What should I do first if a pipe bursts in my London flat?
Turn off the stopcock, then open the cold taps to drain the pipes down. Switch off electrics near the water if it's safe to do so. Then call us and describe what's happened. Older flats often have the stopcock under the sink.
Can a plumber help with a flooded basement in London?
Yes, we can look at the plumbing and drainage side. The Greater London Authority says basement plumbing should account for possible sewer flooding, so pumped drainage and valves on waste lines are worth discussing. Describe the property and we'll take it from there.
Which is more difficult, an electrician or a plumber?
They're different trades, so neither is simply harder. Plumbing means water, waste, heating and pressure, and mistakes show up as leaks. We stick to plumbing and drainage, and we'll tell you if a job needs another trade.
Do you cover the whole of London for plumbing?
We cover Greater London and the towns around it, including Westminster, Islington, Croydon, Harrow, Romford, Sutton and Wimbledon. Call 07401 062636 or use the quote form, and say where the property is.
